Cisco SPA901-NA Administration Guide - Page 54
Configuring the SPA932, Admin, Advanced, Phone, SPA932
View all Cisco SPA901-NA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Chapter 3 Managing Linksys IP Phones Example 3-2 Asterisk Subscribecontext for SPA932 [3500] type=friend secret=3500 callerid="spa3500" nat=no context=home mailbox=3500 Subscribecontext=home ... ... Using the SPA932 (Sidecar) with the SPA962 Configuring the SPA932 Complete the configuration required for the extensions on your SPA9000 IP PBX and obtain the following information, which is required to configure the SPA932: • SPA9000 IP address (or hostname if supported) • Phone extension numbers By default, all LEDs on the SPA932 are assigned to the first configured extension on the SPA962 to which it is connected. You need to assign the LEDs to any of the other five extensions on the SPA962 that you want to monitor using the SPA932. To configure the SPA932, perform the following steps: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Connect to the administration web server for the SPA962 to which the SPA932 is connected. To use the SPA962 with a SPA932, it must be running Release 5.1.12 or later. Click Admin/Advanced on the administration web server page. Click the SIP tab. Select yes from the CTI Enable pull-down selection list. (optional) Change the SPA962 station name. Click the Phone tab and edit the Station Name parameter in the General section. Click the SPA932 tab. If you do not see the SPA932 tab, check your firmware version, and upgrade as necessary. The system displays the page shown in Figure 3-6. Firmware Version 5.1 Linksys IP Phone Administrator Guide 3-11