Cisco WAG54G User Manual - Page 25
RFC 2364 PPPoA, Bridged Mode Only, Save Settings, Cancel Changes, Connect on, Demand, Keep Alive - wireless bridge
View all Cisco WAG54G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Wireless-G ADSL Gateway When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes. RFC 2364 PPPoA Some DSL-based ISPs use PPPoA (Point-to-Point Protocol over ATM) to establish Internet connections. If you are connected to the Internet through a DSL line, check with your ISP to see if they use PPPoA. If they do, you will have to enable PPPoA. • User Name and Password. Enter the User Name and Password provided by your ISP. • Connect on Demand: Max Idle Time. You can configure the Gateway to cut the Internet connection after it has been inactive for a specified period of time (Max Idle Time). If your Internet connection has been terminated due to inactivity, Connect on Demand enables the Gateway to automatically re-establish your connection as soon as you attempt to access the Internet again. If you wish to activate Connect on Demand, click the radio button. In the Max Idle Time field, enter the number of minutes you want to have elapsed before your Internet connection terminates. • Keep Alive Option: Redial Period. If you select this option, the Gateway will periodically check your Internet connection. If you are disconnected, then the Gateway will automatically re-establish your connection. To use this option, click the radio button next to Keep Alive. In the Redial Period field, you specify how often you want the Gateway to check the Internet connection. The default Redial Period is 30 seconds. When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes. Bridged Mode Only If you are using your Gateway as a bridge, which makes the Gateway act like a standalone modem, select Bridged Mode Only. All NAT and routing is disabled in this mode. When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes. Figure 5-7: RFC 2364 PPPoA Figure 5-8: Bridged Mode Only Chapter 5: Configuring the Gateway 18 The Setup Tab