Clifford Concept 450 Owners Guide - Page 15

one-time auto-arming bypass This will bypass the auto arm feature once only. 1. With the key, turn the ignition on, then off within two seconds. 2. The siren will chirp once to confirm auto arming bypass. 3. The system will not auto arm. note: The system will revert to normal auto arming when the system sees the ignition on for at least three seconds. During auto arming bypass the system will not roll up the windows if SmartWindows is connected, and the accessory output will not autoactivate when using the remote to arm the system. low battery warning When the transmitter battery is low, the system will generate a lowpitched tone when disarmed. multiple event total recall This will report the last eight system triggers. 1. Press and hold of the PlainView 2 Valet switch. 2. While still holding release the button. , arm and disarm the system, then 3. The LED will start to blink to indicate the most recent trigger and proceed down to the eighth trigger. If fewer than eight triggers are stored in memory, the LED will blink continuously until the system is armed/disarmed using the transmitter 12