Clifford XL100 Owners Guide - Page 3

Standard Features of the XL100 (cont) AutoArmingTM - Your XL100 arms itself "passively" if you forget to arm it by remotely locking the doors. It may qualify you for an insurance discount that could pay for the system (ask your insurance company). • AutoArmingEnable/Disable -You may disable or re-enable AutoArming with just a few flicks of a switch. • VisualIndication -Two parking light flashes signal that the 30-second countdown to AutoArming has started. • Entry Delay -If you ever temporarily lose the use of your remote, you may set an entry delay of 15 seconds to allow you to enter the car and start the engine without activating the alarm. ■ Instant AutoArm Bypass - Just two quick turns of the ignition switch will bypass AutoArmingforonecycle-perfect when fuelingthe vehicle. AutoArming is automatically restored the next time you park your vehicle.  Duplex Piezo Sensor'', - The two sensor zones provide full perimeter protection. If someone bumps into your car,,the system will sound a warning tone. If forced entry is detected, the fall alarm will sound. Gd AutoTestingn, - Tests all triggers and sensors every time you arm the system. It also warns you if you accidentally arm the system with the door, hood or trunk open. If there is a real trigger or sensor malfunction, the system will alert you whether the problem is a trigger or a sensor.  Patented Malfunction AutoBypassTm -In the unlikely event of a trigger or sensor malfunction, the XL100 will automatically bypass the malfunction and arm all other points to continue relentless protection of your vehicle.  TotalRecallrm - The XL100's memory stores the identity of the last trigger or sensor activated. This provides an invaluable diagnostic means of visually identifying the activated trigger or sensor anytime.  PriorIntrusion AttemptAlert - When you disarm your XL100 by remotely unlocking the doors, a special parking light flash sequence and horn beep acknowledgment will audibly and visually alert you from a distance if an intrusion attempt was foiled while you were away. 4 Standard Features of the XL100 (cant)  Normally Open/ClosedStarter Interrupt - At the time of installation, you can select whether the XLI 00 uses its normally closed or normally open method to ensure that the engine cannot be started by a thief. Normally closed mode ensures that you will be able to start the engine even in the unlikely event of a system malfunction. Normally open mode prevents a thief from starting the engine even if he cuts all the wires or locates and removes the power to the control unit.  Hood/Trunk Trigger Input- For full perimeter protection of the engine compartment and trunk contents (may require optional pin switches).  High-Luminescence LED Status Indicator- Identifies the system status and provides visual deterrence. td Valet Mode - Bypasses the alarm if there is a malfunction, if the remote control battery is dead or if the remote control is lost or stolen.  Selectable Alarm Duration - You may select either a 30-second or 60-second alarm duration.  Patented Noise Abatement Limits alarm to no more than 5 minutes even if a door is left open in the wake of an intrusion attempt. This ensures against battery drain or towing of your vehicle due to noise pollution. The system then automatically re-anns all other points to provide the utmost possible protection.  Patented SmartPowerUpTM II When power to the system is disconnected, the system's non-volatile memory always remembers the last state (armed, disarmed or valet mode) and returns to that state when power is restored. So if a thief disconnects the power and then restores it in an attempt to start the car, the system will re-arm and instantly sound the alarm while immobilizing the vehicle.