Clifford XL1000 Owners Guide - Page 5

Automatic Malfunction Bypass To provide the utmost protection even if a system component malfunctions, the system will automatically bypass the faulty point and arm all other triggers and sensors until you can have the system serviced by your local Authorized Dealer. Smart Prior Intrusion Attempt Alert When you remotely disarm, if you hear 3 chirps instead of the usual one chirp it means that a trigger or sensor was activated in your absence. When you enter the vehicle, the LED will blink several times, pause, then repeat the blink cycle 4 more times. Count the number of blinks in one cycle and refer to the chart below: Number of LED blinks per cycle after disarming 1 blink 2 blinks 3 blinks Trigger/Sensor Activated Vibration/impact sensor or optional sensor Door trigger Trunk or hood trigger TotalRecall™ The system's non-volatile memory records the identity of the last activated or malfunctioning trigger or sensor, which allows your installer to instantly track down a malfunction and save you servicing costs. To identify the trigger or sensor held in the system's non-volatile memory, simply perform the following procedure: 1. With the ignition OFF, flick the valet switch to one side. 2. Press button I to "arm" the system, then again to "disarm." 3. The LED will blink several times, pause, then repeat the blink cycle 4 times. 4. Count the number of blinks in one cycle and refer to the chart that follows: Number of LED blinks per cycle 1 blink 2 blinks 3 blinks Trigger/Sensor that Last Activated or Malfunctioned Vibration/impact sensor or optional sensor Door trigger Trunk or hood trigger LED Status Indicator The LED on your car's dashboard or console will inform you of the system status: LED Condition Off On Flashing Flashing in cycles Meaning System is disarmed Protected valet mode System is armed Smart AutoDiagnostics/TotalRecall of the last activated trigger or sensor (see pages 3-4) or Smart Prior Intrusion Attempt Alert (see above) 4