Coby CX789 User Manual - Page 6

Specifications, Fcc Statement - manual

Page 6 highlights

SPECIFICATIONS Power Source: 3 "D" Size/UM-1 Batteries (DC: 4.5V) Frequency Range: AM 520 - 1710 kHz FM 87.5 - 108 MHz NOAA CH1 - CH7 CH1 162.550 MHz CH2 162.400 MHz CH3 162.475 MHz CH4 162.425 MHz CH5 162.450 MHz CH6 162.500 MHz CH7 162.525 MHz Speaker: 8 ohm 1W Power Output: 200mW Output Jack: Earphone 32 ohm FCC STATEMENT: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules. Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. -  -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6

- ´ -
SPECIFICATIONS
Power Source:
² “D” Size/UM-± Batteries (DC: 4.5V)
Frequency Range:
AM
5³0 – ±7±0 kHz
FM
87.5 – ±08 MHz
NOAA
CH± – CH7
CH±
±´³.550 MHz
CH³
±´³.400 MHz
CH²
±´³.475 MHz
CH4
±´³.4³5 MHz
CH5
±´³.450 MHz
CH´
±´³.500 MHz
CH7
±´³.5³5 MHz
Speaker:
8 ohm ±W
Power Output:
³00mW
Output Jack:
Earphone ²³ ohm
FCC STATEMENT:
This device complies with Part ±5 of the FCC Rules. Operation is subject to the follow-
ing two conditions:
(±) This device may not cause harmful interference, and
(³) This device must accept any interference received, including interference that may
cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for Class
B digital devices, pursuant to Part ±5 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help
Use of shielded cable is required to comply with Class B limits in Subpart B of Part ±5
of the FCC rules.
Do not make any changes or modifications to the equipment unless otherwise specified
in the manual. If such changes or modifications should be made, you could be required
to stop operation of the equipment.