Coby DVD 224 User Manual - Page 21
Should your DVD player develop a problem, please check below before, requesting service - region codes
UPC - 716829982242
View all Coby DVD 224 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Should your DVD player develop a problem, please check below before requesting service: Symptom No Power Does not play No Picture Picture noise / distorted Picture not full screen Problem message display on screen Check and Action Check if the power cord has been properly connected to the power outlet. Check if the main power has been switched on. No disc, load a disc. Disc has been loaded upside down. Place the disc with the label side up. Disc's region code does not match to the player. Disc's rating level is higher than the player's rating level setting Disc is not correct type for the player. Disc is damaged or dirty, clean the disc or try another disc. Moisture may be condensed inside the player. Remove the disc and leave the unit power on for one or two hours. Check if the TV set has power on, use TV remote to select A/V signal for DVD rather than broadcast. Check if the system connection is proper and secure. Check if the connection cables are damaged. Clean the disc. Please press OPEN button,then press PROGRAM and ZOOM button to return factory default status. The disc is dirty or damaged. Clean the disc or try another disc. Reset the color system of the TV set. Try by connect player direct to the TV set, without via a VCR for example. Select the screen format from the player's SETUP MENU, see "SETUP MENU" of this manual. Select the screen format from DVD disc menu. Following message will display when there is a problem with the loaded disc: "WRONG REGIONAL DISC " : Disc's region code dose not match to the player. "WRONG PASSWORD" : The player refuse to play a disc with rating level higher than the player's rating level setting. "WRONG DISC " : The player is equipped with automatic disc quality detection software. When the player detects a problem disc or a damaged disc, the player may keep playing the disc at lower quality or stop playing, depending on the damage level of the disc. Malfunction Press and hold the standby button (if any) for about 5 second to power off. Should the player develop a malfunction, unplug the player for 30 minutes. After 30 minutes, power on the player and the restore function should reset the player.