Compaq 154883-002 Deskpro EN Series of Personal Computers - Slim Desktop Model - Page 59

Diskette Drive, Prepare the computer for disassembly

Get Compaq 154883-002 - Deskpro EN - MT 6600 Model 10000 PDF manuals and user guides
UPC - 743172611697
View all Compaq 154883-002 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 59 highlights

4.15.2 Diskette Drive CAUTION: When the computer is plugged into an AC power source, there is always voltage applied to the system board. You must disconnect the power cord from the power source before opening the computer to prevent system board or component damage. 1. Prepare the computer for disassembly (Section 4.2). 2. Remove access panel (Section 4.6). 3. Rotate the drive cage to the upright position (Section 4.14). 4. Disconnect the drive power cable and signal cable from the drive. 5. Pull the green drive release latch away from the drive 1. 6. Slide the drive out of the drive cage 2. To install a drive, reverse the removal procedure. 4-26 Removal & Replacement Procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
4-26
Removal & Replacement Procedures
4.15.2
Diskette Drive
CAUTION:
When the computer is plugged into an AC power source, there is always voltage
applied to the system board. You must disconnect the power cord from the power source before
opening the computer to prevent system board or component damage.
1.
Prepare the computer for disassembly (Section 4.2).
2.
Remove access panel (Section 4.6).
3.
Rotate the drive cage to the upright position (Section 4.14).
4.
Disconnect the drive power cable and signal cable from the drive.
5.
Pull the green drive release latch away from the drive
1
.
6.
Slide the drive out of the drive cage
2
.
To install a drive, reverse the removal procedure.