Compaq 270680-003 Compaq Desktop Management -- Intelligent Manageability for I - Page 16

Compaq V.90 Integrated Modem Commands 16 Xn Result Code Selection and Call Progress Monitoring This command enables tone detection options used in the dialing process. As these functions are chosen, the result codes of the modem chip set are also affected. Therefore, this command is frequently used to control the responses of the modem chip set. Extension Result Code Dial Tone Detect Busy Tone Detect X0 Disable Disable Disable X1 Enable Disable Disable X2 Enable Enable Disable X3 Enable Disable Enable X4 Enable Enable Enable (default) X5 Enable Enable Enable X6 Enable Enable Enable X7 Disable Enable Enable Extended Result Codes Disabled: Displays only the basic result codes OK, CONNECT, RING, NO CARRIER, and ERROR. Enabled: Displays basic result codes, along with the connect message and the modem's date rate, and an indication of the modem's error correction and data compression operation. Dial Tone Detect Disabled: The modem dials a call regardless of whether it detects a dial tone. The period of time the modem waits before dialing is specified in register S6. Enabled: The modem dials only upon detection of a dial tone, and disconnects the call if the dial tone is not detected within 10 seconds. Busy Tone Detect Disabled: The modem ignores any busy tones it receives. Enabled: The modem monitors for busy tones. Result Codes: OK n = 0, 1, 2, 3, 4, 5, 6, 7 ERROR Otherwise Yn Long Space Disconnect Long space disconnect is always disabled. Y0: Disable long space disconnect (default). Y1: Enable long space disconnect. NOT SUPPORTED. ECG021/1298