Compaq 270680-003 Compaq Desktop Management -- Intelligent Manageability for I - Page 43

Compaq V.90 Integrated Modem Commands 43 +FPR= Select Fax port rate This command sets the DTE to DCE fax port rate. DTE command +FPR = 0 +FPR = 1 +FPR = 2 +FPR = 4 +FPR = 8 +FPR = 10 +FPR = 18 +FPR = ? (if all values listed above are supported) +FPR? (if +IPR = 0) +FPR? (if +IPR = 2400) +FPR? (if +IPR = 4800) +FPR? (if +IPR = 9600) +FPR? (if +IPR = 19200) +FPR? (if +IPR = 38400) +FPR? (if +IPR = 57600) +FPR? (all other +IPR settings) DCE action Execute +IPR = 0 Execute +IPR = 2400 Execute +IPR = 4800 Execute +IPR = 9600 Execute +IPR = 19200 Execute +IPR = 38400 Execute +IPR = 57600 Report (0,1,2,4,8,10,18) Report 0 Report 1 Report 2 Report 4 Report 8 Report 10 Report 18 Report 255 Description or notes Select automatic rate detection Set DTE-DCE to 2400 bit/s Set DTE-DCE to 4800 bit/s Set DTE-DCE to 9600 bit/s Set DTE-DCE to 19200 bit/s Set DTE-DCE to 38400 bit/s Set DTE-DCE to 57600 bit/s DCE supports 2400, 4800, 9600, 19200, 38400, and 57600 bit/s DTE-DCE rate is automatically detected DTE-DCE rate is 2400 bit/s DTE-DCE rate is 4800 bit/s DTE-DCE rate is 9600 bit/s DTE-DCE rate is 19200 bit/s DTE-DCE rate is 38400 bit/s DTE-DCE rate is 57600 bit/s 255 indicates invalid setting +FAA Adaptive Answer A Service Class 1 Facsimile DCE may have the ability to answer as a data modem DCE or as a Facsimile DCE. It also may be able to adaptively change from Class 1 facsimile mode (+FCLASS=1.0) to data modem operation (+FCLASS=0) in response to the incoming call. The +FAA parameter controls this feature. Write syntax: +FAA= Valid values: 0, 1 Default value: 0 Mandatory value: 0 +FAA=0 The DCE answers only as a Class 1 facsimile device. No automatic switching of service class shall occur based on the calling device type. +FAA=1 The DCE can answer and automatically determine whether to answer as a facsimile DCE or as a data modem. If a data modem is detected, the DCE operates as described in 8.3.2.4. ECG021/1298