Compaq 8100 Maintenance and Service Guide: HP Compaq 8100 and 8180 Elite Busin - Page 120
Closing the Expansion Slot Retainer
View all Compaq 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
8. To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis (1) so that the bracket on the card is aligned with the open slot on the rear of the chassis. Press the card straight down into the expansion socket on the system board (2). Figure 7-22 Installing an Expansion Card NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 9. Rotate the slot cover retention latch back in place to secure the expansion card. Figure 7-23 Closing the Expansion Slot Retainer 10. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed. 11. Replace the access panel. 12. If the computer was on a stand, replace the stand. 110 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis