Compaq 8100 Maintenance and Service Guide: HP Compaq 8100 and 8180 Elite Busin - Page 84
Power Switch Assembly
View all Compaq 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Power Switch Assembly The power switch assembly is mounted to the front of the chassis and is removed by pulling it away from the chassis. 1. Prepare the computer for disassembly (Preparation for Disassembly on page 35). 2. Remove the computer access panel (Computer Access Panel on page 43). 3. Remove the computer access panel (Front Bezel on page 44). 4. Disconnect the cable from the black system board connector labeled PB/LED. 5. Press in on the tab (1) on the assembly. 6. Rotate the assembly downward (2), and then pull the assembly away from the chassis while threading the wires through the hole in the front of the chassis. Figure 6-48 Removing the power switch assembly To install the power switch assembly, reverse the removal procedure. 74 Chapter 6 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis