Compaq Armada V300 Compaq Armada E500 and Armada V300 Series Maintenance and S - Page 37
Preliminary Steps, If You Want To, Then Run, IMPORTANT
View all Compaq Armada V300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
The following table describes the troubleshooting actions: If You Want To: Then Run: Check for POST error messages POST Perform any of the following: s Check the system configuration s Set the system power management parameters s Return the system to its original configuration s Check system configuration of installed devices Computer Setup 2.1 Preliminary Steps IMPORTANT: Use AC power when running POST or Computer Setup. A low battery condition could initiate Hibernation and interrupt the test. Before running POST, complete the following steps: 1. Obtain established passwords. If you must clear the passwords, go to Section 2.2. 2. Ensure that the battery pack is installed in the computer and the power cord is connected to the computer and plugged into an AC power source. 3. Turn on the computer. 4. If a power-on password has been established, type the password and press Enter. 5. Run Computer Setup (Section 2.5). If a Setup password has been established, type the password and press Enter. 6. Turn off the computer and all external devices. 7. Disconnect external devices that you do not want to test. If you want to use the printer to log error messages, leave it connected to the computer. 2-2 Troubleshooting