Compaq Mini 311c-1100 HP Pavilion dm1 HP Mini 311 Compaq Mini 311 - Maintenanc - Page 63
to which the keyboard cable is attached, and then, Release the zero insertion force ZIF connector
View all Compaq Mini 311c-1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Removal and replacement procedures 3. Turn the computer display-side up, with the front toward you. 4. Open the computer as far as possible. 5. Lift the rear edge 1 and then the left edge 2 of the keyboard until it rests at an angle. 6. Slide the keyboard 3 back until it rests on the display. 7. Release the zero insertion force (ZIF) connector 1 to which the keyboard cable is attached, and then disconnect the keyboard cable 2 from the system board. 8. Remove the keyboard. Reverse this procedure to install the keyboard. Maintenance and Service Guide 4-23
Removal and replacement procedures
Maintenance and Service Guide
4–23
3. Turn the computer display-side up, with the front toward you.
4. Open the computer as far as possible.
5. Lift the rear edge
1
and then the left edge
2
of the keyboard until it rests at an angle.
6. Slide the keyboard
3
back until it rests on the display.
7. Release the zero insertion force (ZIF) connector
1
to which the keyboard cable is attached, and then
disconnect the keyboard cable
2
from the system board.
8. Remove the keyboard.
Reverse this procedure to install the keyboard.