Compaq d538 HP Compaq Business Desktops d530 Convertible Minitower - Hardware - Page 37

Computer Setup., Replace the computer access panel and front bezel.

Get Compaq d538 - Convertible Minitower Desktop PC PDF manuals and user guides View all Compaq d538 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

Hardware Upgrades If you are installing a third optional drive in the bottom 5.25-inch drive bay, you must also install an expansion card with an IDE controller and data cable (not supplied) because the secondary IDE controller supports only two drives. 6. Connect the drive power 1 and signal 2 cables and, if it is an optical drive and if analog audio is preferred to digital audio, connect the audio cable 3. The other end of the audio cable should be connected to the embedded audio connector on the system board. Connecting the Drive Cables 7. Remove the appropriate bezel blank from the subpanel inside the front bezel. See the "Removing Bezel Blanks" section for more information. 8. Replace the computer access panel and front bezel. 9. If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and enable the Smart Cover Sensor. 10. Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide on the Documentation Library CD for instructions about using Computer Setup. Hardware Reference Guide 2-21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
Hardware Upgrades
If you are installing a third optional drive in the bottom 5.25-inch drive bay, you must
also install an expansion card with an IDE controller and data cable (not supplied)
because the secondary IDE controller supports only two drives.
6.
Connect the drive power
1
and signal
2
cables and, if it is an optical drive and
if analog audio is preferred to digital audio, connect the audio cable
3
. The other
end of the audio cable should be connected to the embedded audio connector on
the system board.
Connecting the Drive Cables
7.
Remove the appropriate bezel blank from the subpanel inside the front bezel. See
the
“Removing Bezel Blanks”
section for more information.
8.
Replace the computer access panel and front bezel.
9.
If you normally lock the Smart Cover Lock, use Computer Setup to relock the
lock and enable the Smart Cover Sensor.
10. Reconfigure the computer, if necessary. Refer to the
Computer Setup (F10)
Utility
Guide
on the
Documentation Library
CD for instructions about using
Computer Setup.
Hardware Reference Guide
2-21