Craftsman 10723 Owners Manual - Page 4

SAFETY INSTRUCTIONS cont. ELECTRICAL SAFETY cont. 4. AVOID body contact with grounded surfaces, such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. 5. DO NOT expose power tools to rain or wet conditions or use power tools in wet or damp locations. Water entering a power tool will increase the risk of electric shock. 6. INSPECT tool cords for damage. Have damaged tool cords repaired at a Sears Service Center. BE SURE to stay constantly aware of the cord location and keep it well away from the moving blade. 7. DO NOT abuse the cord. NEVER use the cord to carry the tool by or to pull the plug from the outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords increase the risk of electric shock. EXTENSION CORDS Use a proper extension cord. ONLY use cords listed by Underwriters Laboratories (UL). Other extension cords can cause a drop in line voltage, resulting in a loss of power and overheating of tool. For this tool an AWG (American Wire Gauge) size of a least 14-gauge is recommended for an extension cord of 25 - ft. or less in length. Use 12 - gauge for an extension cord of 50 - ft. Extension cords 100-ft. or longer are not recommended. Remember, a smaller wire gauge size has greater capacity than a larger number (14 - gauge wire has more capacity than 16-gauge wire; 12-gauge wire has more capacity than 14 - gauge). When in doubt use the smaller number. When operating a power tool outdoors, use an outdoor extension cord marked "W-A" or "W". These cords are rated for outdoor use and reduce the risk of electric shock. ! CAUTION: Keep the extension cord clear of the working area. Position the cord so that it will not get caught on lumber, tools, parts of the vehicle or other obstructions while you are working with a power tool. ! WARNING: Check extension cords before each use. If damaged replace immediately. Never use tool with a damaged cord since touching the damaged area could cause electrical shock, resulting in serious injury. 6 SAFETY INSTRUCTIONS cont. SAFETY SYMBOLS FOR YOUR TOOL The label on your tool may include the following symbols. V Volts A Amps Hz Hertz W Watts min Minutes Alternating current Direct current no No-load speed Class II construction, Double Insulated RPM Revolutions per minute SPM Strokes per minute OPM Orbits per minute Indicates danger, warning or caution. It means attention! Your safety is involved. SERVICE SAFETY 1. If any part of this tool is missing or should break, bend, or fail in any way; or should any electrical component fail to perform properly: SHUT OFF the power switch and remove the tool's plug from the power source and have the missing, damaged or failed parts replaced BEFORE resuming operation. 2. Tool service must be performed only at a Sears Service Center. Service or maintenance performed by unqualified personnel could result in a risk of injury. 3. When servicing a tool, use only identical replacement parts. Follow instructions in the maintenance section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury. SAFETY RULES FOR BUFFER / POLISHERS ! WARNING: USE OF ACCESSORIES THAT ARE NOT RECOMMENDED FOR USE WITH THIS TOOL MAY CREATE A HAZARDOUS CONDITION. 1. Read, understand and follow all safety rules and user instructions in this manual and all directions and warnings on polishes and waxes BEFORE using this buffer / polisher. 2. Vehicle should be clean and dry before using your buffer polisher. Remove all road tar, excess grease spots and bug stains. 3. ALWAYS make sure the vehicle's surface is cool before washing and using the buffer / polisher. 4. When changing accessories, BE SURE that the switch is in the OFF position and the cord is unplugged. 5. DO NOT apply wax directly on car. 7