Craftsman 28195 Product Manual - Page 29
snugly, but do not over-tighten.
View all Craftsman 28195 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
3. Using a slotted screwdriver, remove the black, plastic cap on each side of the motor (Fig. 20), and carefully withdraw the spring-loaded brush assemblies. Keep brushes clean and sliding freely in their guide channels. Fig. 20 NOTE: To reinstall the same brushes, make sure that the brushes go back in the same way they came out. This will avoid the need for a Plastic Cap "run-in" period. 4. Insert new brush assemblies into the guide channels with the carbon part going in first, being certain to fit the two metal "ears" into their slots in the channel (Fig. 20). 5. Remember to replace both end caps after inspecting or servicing brushes. Tighten the caps snugly, but do not over-tighten. Before use, the saw should be allowed to "RUN IN" (run at no load without a blade) for 5 minutes to seat the new brushes properly. 28195 Manual_Revised_07-0623 Page 29