Cub Cadet 3X 28 3X 26034 Operator's Manual - Page 12
Set-Up
View all Cub Cadet 3X 28 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
4. Remove the hairpin clip from the rear of the chute control assembly. 5. Insert flex shaft removed earlier from the lower handle into rear of the chute directional control head. Secure the flex shaft to the chute control head with the hairpin clip removed earlier. See Figure 3-17 . 7. Remove the cotter pin and washer from the ferrule on the end of the shift rod. See Figure 3-19 inset. Figure 3-17 6. Insert the flex shaft into the chute control rod coupling under the dash panel. See Figure 3-18. Figure 3-19 8. Insert the ferrule into the top hole of the shift lever and secure with the cotter pin and washer removed in the previous step. 9. Check that all cables are properly routed through the cable guide on top of the engine. See Figure 3-10. Set-Up Shear Pins Storage Replacement auger shear pins and bow tie cotter pins are included with your snow thrower. Store them in your snow thrower's dash panel until needed. See Figure 3-20. Figure 3-18 12 Section 3- Assembly & Set-Up Figure 3-20