Cub Cadet 945 SWE Two-Stage Snow Thrower 945 SWE Operator's Manual - Page 12
Two-Way Chute Control™, Auger Control, Drive Control / Auger Clutch Lock
View all Cub Cadet 945 SWE Two-Stage Snow Thrower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Auger Control The auger control is located on the left handle. Squeeze the control grip against the handle to engage the augers and start snow throwing action. Release to stop. Two-Way Chute Control™ The two-way chute control is located on the left side of the dash panel and is used to control the distance of snow discharge from the chute. • To change the upper chute angle to control the distance that snow is thrown, pivot the lever forward or backward. • Move the lever forward to pivot the upper chute down and reduce the distance snow is thrown. • Move the lever rearward to pivot the upper chute upward and increase the distance snow is thrown. CHUTE DIRECTIONAL CONTROL Drive Control / Auger Clutch Lock The drive control is located on the right handle. Squeeze the control grip against the handle to engage the wheel drive. Release the handle to stop. DISCHARGE LEFT DISCHARGE RIGHT CHUTE TILT DOWN CHUTE TILT UP NOTE: To increase or decrease the tension on the two-way chute control, tighten or loosen the wing knob on the chute assembly as shown in Figure 4-1. The drive control also locks the auger control so that you can operate the chute directional control without interrupting the snow throwing process. If the auger control is engaged simultaneously with the drive control, the operator can release the auger control (on the left handle) and the augers will remain engaged. Release both controls to stop the augers and wheel drive. NOTE: Always release the drive control before changing speeds. Failure to do so will result in increased wear on your machine's drive system. Figure 4-1 12 Section 4- Controls and Features