Cub Cadet 945 SWE Two-Stage Snow Thrower 945 SWE Operator's Manual - Page 22
Troubleshooting
View all Cub Cadet 945 SWE Two-Stage Snow Thrower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Troubleshooting 8 Problem Excessive vibration Cause 1. Loose parts or damaged auger. Loss of power 1. Spark plug wire loose. 2. Gas cap vent hole plugged. Unit fails to propel itself 1. Drive control cable in need of adjustment. Unit fails to discharge snow 2. Drive belt loose or damaged. 3. Friction wheel worn. 1. Chute assembly clogged. Chute Fails to Rotate 2. Foreign object lodged in auger. 3. Auger control cable in need of adjustment. 4. Auger belt loose or damaged. 5. Shear pin(s) sheared. 6. Improper adjustment of Chute Bracket. Remedy 1. Stop engine immediately and disconnect spark plug wire. Tighten all bolts and nuts. If vibration continues, have unit serviced by an authorized Service Center. 1. Connect and tighten spark plug wire. 2. Remove ice and snow from gas cap. Be certain vent hole is clear. 1. Adjust drive control cable. Refer to Maintenance section 2. Replace drive belt. 3. Replace Friction Wheel. 1. Stop engine immediately and disconnect spark plug wire. Clean chute assembly and inside of auger housing with clean-out tool or a stick. 2. Stop engine immediately and disconnect spark plug wire. Remove object from auger with clean-out tool or a stick. 3. Refer to Auger Control Test. 4. Refer to Maintenance section. 5. Replace with new shear pin(s). 7. Refer to Maintenance Section for Chute Bracket Adjustment. 22