Cub Cadet LGT 1054 LGT 1050 Operator's Manual - Page 16
Driving The Tractor, Steering Tractors Equipped with Power Steering, Reverse Caution Mode
View all Cub Cadet LGT 1054 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Driving The Tractor WARNING! Avoid sudden starts, excessive speed and sudden stops. Note: While on pavement, operating the power steering with the engine running and the tractor at a stand-still, may cause the front wheels to stutter. This is considered normal and will operate smoothly under typical mowing conditions. Reverse Caution Mode 1. Lightly press the brake pedal to release the parking brake. The REVERSE CAUTION MODE position of the key switch module Move the throttle lever into the FAST (rabbit) position. allows the tractor to maneuver in reverse with the blades (PTO) NOTE: When operating the tractor, be certain that the engaged. throttle/choke control is always in the FAST (rabbit) NOTE: Mowing in reverse is not recommended. position. Operating with the throttle at less than full throttle may lead to shortened battery life, and poor cut quality. 2. To travel FORWARD, slowly press the upper portion of the drive pedal forward until the desired speed is achieved. See Figure 5-1. WARNING! Use extreme caution while operating the tractor in the REVERSE CAUTION MODE. Always look down and behind before and while backing. Do not operate the tractor when children or others are around. Stop the tractor immediately if someone enters the area. To use the REVERSE CAUTION MODE: NOTE: The operator MUST be seated in the tractor seat. 1. Start the engine as previously instructed on the previous page. 2. Turn the key from the NORMAL MOWING (Green) position to the REVERSE CAUTION MODE (Yellow) position of the key switch module. See Figure 5-2. Drive Pedal Reverse Pedal Indicator Light Stop Position Reverse Push Button Reverse Caution Mode Position Figure 5-1 3. To travel in REVERSE, check that the area behind is clear, then slowly depress the lower portion of the drive pedal with the ball of your foot (NOT your heel) until the desired speed is achieved. See Figure 5-1. CAUTION: Do NOT attempt to change the direction of travel when the tractor is in motion. Always bring the tractor to a complete stop before moving the tractor from forward to reverse or vice versa. WARNING! Do not leave the seat of the tractor without first placing the PTO/Blade Engage knob in the disengaged (OFF) position and engaging the parking brake. If leaving the tractor unattended, also turn the engine off and remove the ignition key. Steering Tractors Equipped with Power Steering When operating tractors equipped with power steering, do not force the steering wheel to turn all they way to the left or right. When reaching the end of the turning radius, allow the steering wheel to back off slightly and avoid holding the wheel all the way up against the steering stops. Start Position Figure 5-2 3. Press the REVERSE PUSH BUTTON (Orange, Triangular Button) at the top, right corner of the key switch module. The red indicator light at the top, left corner of the key switch module will be ON while activated. See Figure 5-2. 4. Once activated (indicator light ON), the tractor can be driven in reverse with the cutting blades (PTO) engaged. 5. Always look down and behind before and while backing to make sure no children are around. After resuming forward motion, return the key to the NORMAL MOWING position. The REVERSE CAUTION MODE will remain activated until: a. The key is placed in either the NORMAL MOWING position or STOP position or b. The operator leaves the seat. 16 Section 5 - Operation