Cub Cadet RZT L 42 H Operation Manual - Page 9

Assembly & Set-Up 3 Contents of Crate • One Lawn Tractor • One RZT Tractor Operator's Manual • One Oil Drain Tube • One Kohler Engine Operator's Manual • One Deck Wash Hose Coupler Tractor Preparation 2. Remove the two shoulder bolts and lock nuts in the seat bracket as shown in Fig. 3-2. Remove the upper crating material from the shipping pallet, and cut any bands or tie straps securing the tractor to the pallet. Use the lift handle to raise the deck to its highest position. Engage the transmission bypass rods on each side of the tractor; then carefully roll the tractor off the shipping pallet. The transmission bypass rods (one for each the RH and LH transmission) are located beneath the frame platform, just inside each rear wheel. Disengage the bypass rods. See Fig. 3-1. Seat Bracket RH Transmission Bypass Rod Pull Out Bypass Rod Then Lower Into Slot Lock Nuts Wire Harness Keyhole Slot Shoulder Bolts Figure 3-2 3. Rotate the seat into position and secure the seat into place with the previously removed shoulder bolts and lock nuts. Be careful not to crimp or damage the wire harness while installing the seat. See Fig. 3-3. Figure 3-1 Remove the deck wash system nozzle adapter and oil drain tube from the manual bag and store for future use. Install Operator's Seat To install the seat proceed as follows: NOTE: The seat is shipped with the seat switch and seat pan attached. 1. Cut any straps securing the seat assembly and the drive control levers to the tractor. Remove any packing material. NOTE: Be careful not to cut the wiring harness connecting the seat and the seat switch. Lock Nuts Shoulder Bolts Figure 3-3 Wire Harness Seat Bracket 9