Cub Cadet SC 100 H Operation Manual - Page 7

B C (a) (b) C A (b) (a) Figure 2-5 6. The rope guide is attached to the right side of the upper handle. Loosen the wing knob (a) which secures the rope guide. See Figure 2-6. A D Figure 2-7 2. Follow steps below to attach grass catcher: See Figure 2-8. a. Lift mower rear discharge door. b. Place grass catcher into the slots in the handle brackets. Let go of discharge door so that it rests on the grass catcher. (a) B (a) C Figure 2-6 a. Hold blade control against upper handle. b. Slowly pull starter rope handle from engine and slip starter rope into the rope guide. c. Tighten rope guide wing knob (a). d. Use cable tie(s) to secure cable(s) to lower handle. Grass Catcher (If Equipped) 1. Follow steps below to assemble the grass catcher (if needed). Make certain bag is turned right side out before assembling (warning label will be on the outside). See Figure 2-7. a. Place bag over frame so that its black plastic side is at the bottom. b. Slip plastic channel of grass bag over hooks on the frame. B A B Figure 2-8 To remove grass catcher, lift mower rear discharge door. Lift grass catcher up and off the slots in the handle brackets. Release mower rear discharge door to allow it to close rear opening of mower. Side Discharge Chute (If Equipped) Your mower may be shipped as a mulcher. To convert to side discharge, make sure grass catcher (if equipped) is off the unit and mower rear discharge door (if equipped) is closed. 1. On the side of the mower, lift the mulch plug. See Figure 2-9. Mulching Plug 1 2 Figure 2-9 2. Slide two hooks of side discharge chute under hinge pin on mulch plug assembly. Lower the mulch plug. NOTE: Do not remove mulch plug at any time. Adjustments Cutting Height The cutting height adjustment lever is located above the front and rear right wheel. NOTE: On select models, the front cutting height adjustment lever is located above the front left wheel. Refer to Figure 2-10 and the following instructions to adjust cutting height. Higher 3 1 2 Lower 2 Higher 3 Lower 1 Figure 2-10 1. Pull the cutting height adjustment lever towards wheel. Section 2 - Assembly & Set-Up 7