Cuisinart DOKITCHAPP5541044 BFP-703 Manual - Page 7

QUICK REFERENCE GUIDE FOR BLENDER FUNCTION To activate blender To begin blending To change speeds To pulse To crush ice To stop blending and deactivate blender To stop blending in Pulse or Ice Crush mode To stop blending in Stir, Chop, Mix, Purée, or Food Processor mode Press On- The blender is in On mode. Press desired speed button. Press desired speed button. In On mode press Pulse, then press and release desired speed button as needed. In On mode, press and release Ice Crush button as needed. Press Off button. Release button. Press speed button again. This will return the blender to On mode. Press Off button to turn blender off. SPEED SELECTION GUIDE FOR BLENDER FUNCTION Refer to this guide to choose the best speed for your desired result. Ingredient/Recipe Reconstituting frozen orange juice concentrate Mayonnaise Salad dressings Nuts Whipping cream Bread crumbs Grating citrus zest Milk shakes Baby food Health drinks Frozen cocktails Grinding hard cheese Spices Ice Speed Stir Stir Stir Chop Mix Mix Purée Purée Purée Food Processor Food Processor Food Processor Food Processor Ice Crush Result Smooth and full-bodied Thick and creamy Desired consistency Coarse to fine Thick topping Uniformly fine Uniformly fine Smooth and creamy Smooth and creamy Smooth and creamy Thick and slushy Coarse to fine Coarse to fine Snowy CLEANING AND MAINTENANCE Always unplug your Cuisinart® SmartPower Duet® Blender/Food Processor from the electrical outlet before cleaning. The blender is made of corrosion-resistant parts that are easy to clean. Before first use and after every use, clean each part thoroughly. Periodically check all parts before reassembly. If any part is damaged or blender jar is chipped or cracked, DO NOT USE BLENDER. Remove the blender jar from the motor base by lifting straight up and away. Twist off the locking ring by turning counterclockwise. Remove the cutting assembly and rubber gasket. Wash in warm soapy water; rinse and dry thoroughly. Place the locking ring in the upper rack of the dishwasher or wash in warm water. CAUTION: Handle the cutting assembly carefully. It is SHARP and may cause injury. Do not attempt to remove blades from cutting assembly. Remove the blender jar cover and the measured pour lid. Wash in warm, soapy water; rinse and dry thoroughly, or place in the upper rack of the dishwasher. The blender jar should be washed in warm soapy water and rinsed and dried thoroughly. The blender jar can also be placed upside down in the dishwasher. Finally, wipe the motor base clean with a damp cloth to remove any residue, and dry thoroughly. Never submerge the motor base in water or other liquid, or place in the dishwasher. Tip: You may wish to clean your blender cutting assembly as follows: Squirt a small amount of dishwashing liquid into assembled blender jar and fill halfway with warm water. Run on Stir for 15 seconds. Repeat using clean tap water. Empty blender jar and carefully disassemble parts. Wash cutting assembly, gasket and locking ring in warm, soapy water. Rinse and dry all parts thoroughly. 7