D-Link DCS-45 User Manual - Page 1

Model No.: DCS-45 User's Manual Ⅰ. Introduction The DCS-45 camera housing is built using die-cast aluminum, powder coated and stove finished. The design and manufacture is adapted to the highest technical standard with IP 66 level of environmental protection. The housing is provided with an adjustable semi-cablemanaged mounting bracket. Ⅱ. Mounting configuration of DCS-45 1. Use the rear section of the mounting bracket (D) as a template for marking the position of the mounting holes (H). Remove and drill the holes accordingly. (K) 2. Attach the mounting bracket arm to the wall using the rawlplugs and screws provided. (D) (E) (G) (F) 3. Attach the main housing enclosure (K) to the mounting bracket with two of 1/4" x 14.7 mm trilobular screws (F) provided. 4. Release screw (E) on the mounting bracket to pan the housing and then release screw (G) to tilt the housing. Position the housing as required for the correct camera coverage and then securely tighten the screws. Fig.1 5. Feed cables through the cover plate (B) of the mounting bracket from the wall, or by using cable conduits. 90° 90° (B) Fig.2 65 (H) 78 Inner space for camera mount W90 x H70 x L230mm 1