D-Link DCS-45 User Manual - Page 2

Ⅲ. Fitting instructions for camera 5 1 Fig.3 4 (A) 23 (C) 1 Camera mounting platform 2 Terminal block assembly 3 Cable conduits PGB13.5 x 2 4 Captive retainning 1/4" Screws x 3 5 Ground wire (H) (G) (B) (C) (F) (E) (J) (D) (G) (I) 1. Unscrew the 3 captive retaining screws (C) and remove the housing cover (A) from the housing base (B). 2. Release the 4 keyhole screws (F) and then slide and withdraw the camera platform (G) from the housing base (B). 3. Mount the camera (H) onto the camera platform (G) using the 1/4" UNC screw (I) supplied, ensuring that the insulation pad (J) is mounted between the platform and the camera. Always check if the camera is firmly attached to the platform. 4. Connect the camera power cable to the rear terminal block (E) through the first cable conduit (D). 5. Connect the video cable to the camera through the second cable conduit (D). IMPORTANT NOTE: ALWAYS UNPLUG THE TOP SECTION OF THE EARTH WIRE FROM THE BASE WIRE WHEN DISASSEMBLING THE HOUSING. REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER AGAIN WHEN REASSEMBLING THE HOUSING. 2