D-Link DCS-920 Product Manual - Page 29
Setup > Wireless - wireless setup
UPC - 790069313783
View all D-Link DCS-920 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Section 3 - Configuration Setup > Wireless In this section, you can setup and configure the wireless settings on your camera. Note: Wireless is available only for the DCS-920. Wireless Interface SSID: Service Set Identifier, an identifier for your wireless network. Channel: The default setting is channel 6. Select the same channel that is using by other wireless devices within your network. When there is interference from the wireless networks that overlap with one another, you may change the channel to obtain maximum performance for your connection. Connection Mode: Infrastructure is a wireless connection using an access point as a transmission point of all wireless devices. Ad-Hoc is a wireless connection used without an access point, where your DCS-920 is directly connecting to your PC. This is done using the on-board wireless adapter on the DCS-920 connected to a wireless adapter on the PC. Site Survey: This page will allow you to select a wireless network that the DCS-920 was able to detect upon booting up. WPS: This option will allow you to run the Wi-Fi Protected Setup directly from your DCS-920 Web GUI. Wireless Security For security, there are three choices; None, WEP, and WPA-PSK / WPA2-PSK. Select the same encryption method that is being Mode: used by your wireless device/ router. WPA-PSK / WPA2PSK An appropriate Preshared Key, which is needed in order to connect to the wireless network.. Settings: D-Link DCS-910/920 User Manual 29