D-Link DFL-860E CLI Guide for DFL-260E - Page 163
Enables the Host Monitoring functionality. Default - d link manual
View all D-Link DFL-860E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
3.49.2. Route Chapter 3. Configuration Reference Comments Text describing the current object. (Optional) Note If no Index is specified when creating an instance of this type, the object will be placed last in the list and the Index will be equal to the length of the list. 3.49.2. Route Description A route defines what interface and gateway to use in order to reach a specified network. Properties Name Interface Gateway LocalIP Network RouteMonitor MonitorLinkStatus MonitorGateway MonitorGatewayManualARP MonitorGatewayARPInterval EnableHostMonitoring Reachability GracePeriod Specifies a symbolic name for the object. (Optional) Specifies which interface packets destined for this route shall be sent through. Specifies the IP address of the next router hop used to reach the destination network. If the network is directly connected to the security gateway interface, no gateway address is specified. (Optional) The IP address specified here will be automatically published on the corresponding interface. This address will also be used as the sender address in ARP queries. If no address is specified, the security gateway's interface IP address will be used. (Optional) Specifies the network address for this route. Specifies if this route should be monitored for route changes for route failover purposes. (Default: No) Mark the route as down if the interface link status changes to down. (Default: No) Mark the route as down if the next hop does not answer on ARP lookups during a specified time. (Default: No) Enable a manually specified ARP lookup interval. (Default: No) Specifies the ARP lookup interval in milliseconds. (Default: 1000) Enables the Host Monitoring functionality. (Default: No) Specifies the number of hosts that are required to be reachable to consider the route to be active. (Default: ALL) Specifies the time to wait after a reconfiguration until the monitoring begins. (Default: 5) 163