D-Link DP-301 Product Manual - Page 12

DP-301 Print Server Hardware Guide steady long flashes continuous on One long, two short flashes One long, three short flashes One long, four short flashes One long, five short flashes One long, six short flashes One long, seven short flashes One long, eight short flashes One long, nine short flashes steady short flashes One long, eleven short flashes Firmware Reload Required DRAM Error Timer INT Error Flash Protected Flash ID Error Flash Erase / Program Error LAN Controller Error LAN Memory Error Parallel Controller Error LPT Error EERPROM Error LAN I/O Base error In the event of a Firmware Reload Required error at startup, proceed according to instructions given in the PS Admin User's Guide ("PS Admin Administration" section, under the heading "Upgrading the Print Server's Internal Firmware"). In the event that any of the other listed error conditions is encountered on startup, contact your dealer for correction of the fault. Operational Test The PS Admin software includes a Print Test function for confirmation of connections and functions. That operational test can be performed after you have completed installation of the PS Admin software, and the PS Admin procedures for configuring the DP-301. See instructions given in the PS Admin User's Guide ("Getting Started Setting up Your Print Server" section, under the heading "Testing your Print Server"). Velcro-mounting the DP-301 The DP-301 can stand on the printer's tabletop, or may be Velcro-mounted to a side panel of the printer or another suitable surface next to the printer. To prepare for Velcro-mounting, separate the two parts of the supplied Unpacking and Installation 9