D-Link DPR-2000 Manual - Page 15
Power ON Self-Test - a
View all D-Link DPR-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Setting up the DPR-2000 Check your D-Link web site for the lasted updated list. This section will describe the installation steps for a wired Ethernet connection. Follow the steps below to avoid any complications during the hardware installation: 1. Confirm that all the printers that you will connect to the DPR-2000 are operating correctly. 2. When you have confirmed that the printers are operating correctly, switch their power OFF. 3. Confirm that your network is operating normally. 4. Use a Cat. 5 Ethernet cable, connect the DPR-2000's Ethernet LAN port to an Ethernet LAN port of an Ethernet switch or router. 5. While the printer is turned OFF, connect the USB cables to the printers and then to the USB ports on the DPR-2000. 6. Turn ON the powers of the printers. 7. Insert the power adapter's output plug into the power socket on the rear panel of the DPR-2000. 8. Connect the other end of the power adapter into an AC power outlet. This will supply power to the DPR-2000. The blue LED on the DPR-2000's front panel should turn ON and this Print Server's self-test will proceed. Power ON Self-Test Every DPR-2000 has been factory-tested to operate properly. When the DPR-2000 is powered ON, it automatically performs a Self-Test on each of its major components. The final result of the Self-Test is signaled by the state of the USB LED indicators following the Self-Test. Preliminary to the actual component tests, all LED indicators are tested to confirm their operation. D-Link DPR-2000 - User Manual 10