Danby DBC514BLS Product Manual - Page 9
Installation Instructions - Intergrated Application, Preparing the, Enclosure, Tools You Will - beverage center by
View all Danby DBC514BLS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation Instructions - Intergrated Application Tools You Will Need Safety Glasses Gloves Level FOR YOUR SAFETY: While performing installations described in this section, gloves, safety glasses or goggles should be worn. Drill & Hole Saw set Flashlight Measuring Tape Carpenters Square Preparing the Enclosure Electrical Requirements: The appliance must be connected to an individual properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse. • It is recommended that you de not install the beverage center into a corner (i.e. directly beside a wall). This is to allow the door(s) to have a greater then 90° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gasket(s). • The rough cabinet opening must be on a level floor area and at least 25" deep by 24" wide. The opening should also have a height of at least 35". • The electrical oulet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig C.). • If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2" diameter hole to admit the power cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet. 35" From Underside of Countertop to Floor 1-1/2" dia. hole *if electical outlet is in adjacent cabinetry 24" 2"Min. Electrical Access 6" Cabinets Square and Plumb 24" Fig C 8