Danby DPAC10099 Use and Care Guide - Page 4

PART IDENTIFICATION Air Exhaust: For air to be cooled and filtered. Opens / Closes automatically. LCD Display Air Filter Air inlet Front Panel Handles Air outlet Cover Air inlet Wheels Electricity cable Water drain IMPORTANT SAFETY INFORMATION READ ALL SAFETY INFORMATION BEFORE USING ELECTRICAL SPECIFICATIONS 1) Check available power supply and resolve any wiring problems BEFORE installation and operation of this unit. All wiring must comply with local and national electrical codes and be installed by a qualified electrician. If you have any questions regarding the following instructions, contact a qualified electrician. 2) This appliance draws 7.8 nameplate amps under Cooling Mode and may be used in any properly wired, general purpose 15 amp household grounded receptacle. 3) For your safety and protection, this unit is grounded through the power cord plug when plugged into a matching wall outlet. If you are not sure whether the wall outlets in your home are properly grounded, please consult a qualified electrician. TABLE 1 Suggested Individual Branch Circuit Nameplate Amps 9.5 *AWG Wire Size 16 AWG- American Wire Gauge *Based on copper wire at 60°C temperature rating. TABLE 2 Receptacle and Fuse Types Rated Volts 125 Amps 13 Wall Outlet WARNING: Improper connection of the grounding plug can result in risk of Fire, Electric Shock, and/or injury to Persons associated with the appliance. Check with a qualified service representative if in doubt that the appliance is proplery grounded. 4) DO NOT USE PLUG ADAPTERS OR EXTENSION CORDS WITH THIS UNIT. If it is necessary to use an extension cord with this unit, use an approved "air conditioner" extension cord only (available at most local hardware stores). 5) To avoid the possibility of personal injury, always disconnect the power supply to the unit before installing and/or servicing. Fuse Size Time Delay Fuse (or Circuit Breaker) 15 Plug Type CAUTION: Do not leave this unit unattended in a space where people or animals cannot react to a failed unit are located. A failed unit can cause extreme overheating or death in such an enclosed, unattended space. 3