Danby DPAC9008 User Manual - Page 11

Air Conditioner Operating Instructions (cont'd) 4) Press the FAN key Fig F (1) to select the desired fan speed setting (Auto-Low-Med-High). Your selection will appear in the display window leach depression of the fan key will advance to a different setting). 5) Press the SWING key Fig F (2) to activate the automatic air swing (oscillating) feature and the swing symbol will appear in the display window. Fig G. To deactivate the air swing feature. press the SWING key again. 6) The horizontal louvers open and dose automatically when the unit is switched on and off. To adjust -air flow' direction, (up / down only) adjust the center louver only up or down Fig 16. The blue indicator light will come on indicating the air-conditioning mode is operational (there may be a slight delay of 10-30 seconds before the cycle begins, this is normal). Cooling stops automatically when the set temperature is achieved. Cooling resumes when the room temperature uses above the sot temperature level. The temperature has no effect on the fan operation. Therefore. the fan will operate oonfinuously (after the compressor has cycled off) to maintain optimal temperature control. CAUTION A During air conditioning and dehumidifying modes, if the compressor cycle is interupted (unplugged, power failure.etc.) and reinstated immediately thereafter, (within 3-5 minutes) a "compressor protection circtur is automatically self-activated. The compressor cannot operate during a "compressor protecton" condition. (this is normal) It may take 3-5 minutes before the "protection circuit" self-deactivates. DO NOT ATTEMPT TO START THE UNIT (COMPRESSOR) DURING THIS PERIOD. Upon reinstating power to the unit all previous settings (I.e. time, mode, fan speed• auto timed programs) are lost and will have to be re-entered. 1 2 'c Iv RE:1, ede -A " Fie ffl FigAs A ATTENTION A When the unit beeps and the (red) 'water full" indicator light Illuminates and flashes continuously. please (re)install the external water tank. 10