Dell C1048P Port Extender Networking C1048P Installation Guide - Page 15

Connecting to a C9010 Switch, Mounting the C1048P in a 2-Post Rack

Get Dell C1048P Port Extender PDF manuals and user guides View all Dell C1048P Port Extender manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Figure 7. Mounting the C1048P in a 2-Post Rack Connecting to a C9010 Switch The C1048P port extender has two 10G SFP+ ports on the front panel (see Figure 2). The two SFP+ ports provide 10GbE uplinks to a C9010 switch with SFP+ transceivers. At least one 10GbE SFP+ uplink is required to connect to a C9010 switch. NOTE: A C1048P can connect to a C9010 switch only through a 10GbE SFP+ port; a C1048P cannot connect to a C9010 through a 10/100/1000 Mbps RJ-45 port. CAUTION: ESD damage can occur if the components are mishandled. Always wear an ESDpreventive wrist or heel ground strap when handling the PE and its components. WARNING: When working with optical fibres, follow all the warning labels and always wear eye protection. Never look directly into the end of a terminated or unterminated fibre or connector as it may cause eye damage. To connect to a C9010: 1. Position the SFP+ optic correctly over a port. The optic has a key that prevents it from being inserted incorrectly. 2. Insert the optic into an SFP+ port until it gently snaps into place. 3. Connect one end of an appropriately connectorized fiber-optic cable into the port. Connect the other end to an SFP+ connector in a C9010 switch. Installing the Hardware 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
Figure 7. Mounting the C1048P in a 2-Post Rack
Connecting to a C9010 Switch
The C1048P port extender has two 10G SFP+ ports on the front panel (see Figure 2). The two SFP+ ports
provide 10GbE uplinks to a C9010 switch with SFP+ transceivers. At least one 10GbE SFP+ uplink is
required to connect to a C9010 switch.
NOTE:
A C1048P can connect to a C9010 switch only through a 10GbE SFP+ port; a C1048P
cannot connect to a C9010 through a 10/100/1000 Mbps RJ-45 port.
CAUTION: ESD damage can occur if the components are mishandled. Always wear an ESD-
preventive wrist or heel ground strap when handling the PE and its components.
WARNING: When working with optical fibres, follow all the warning labels and always wear eye
protection. Never look directly into the end of a terminated or unterminated fibre or connector
as it may cause eye damage.
To connect to a C9010:
1.
Position the SFP+ optic correctly over a port. The optic has a key that prevents it from being inserted
incorrectly.
2.
Insert the optic into an SFP+ port until it gently snaps into place.
3.
Connect one end of an appropriately connectorized fiber-optic cable into the port. Connect the
other end to an SFP+ connector in a C9010 switch.
Installing the Hardware
15