Dell C9000 Line Cards Networking Command-Line Reference Guide for the C9000 Se - Page 1121

Related Commands Version 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. show ip interface - displays the interface routing status and configuration. ip route Assign a static route to the switch. C9000 Series Syntax ip route {destination mask {ip-address | interface [slot/port] | [tunnel tunnel-id] [distance] | [permanent] | tag tag-value}} [vrf vrf-name ] To delete a specific static route, use the no ip route destination mask command. To delete all routes matching a certain route, use the no ip route destination mask command. Parameters destination mask Enter the IP address in dotted decimal format of the destination device. Enter the mask in the slash prefix format (/x) of the destination IP address. ip-address Enter the IP address of the forwarding router in dotted decimal format. interface interface Enter one of the following keywords and slot/port or number information: • For a null interface, enter the keyword null then the slot/port information. The Null interface number is 0. • For a Management Ethernet interface, enter the keyword managementethernet then the slot/port information. • For a Loopback interface, enter the keyword loopback then the slot/port information. The range is from 0 to 16383. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. IPv4 Routing 1121