Dell C9000 Line Cards Networking Command-Line Reference Guide for the C9000 Se - Page 2088

Parameters seconds Enter the number of seconds for the delay. The range is from 0 to 900 (0 indicates no delay). Defaults 0 Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.0.0.0 8.3.19.0 8.3.8.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S4820T. Introduced on the S4810. Usage Information This command applies to all the VRRP configured interfaces on a system. When used with the vrrp delay minimum CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay minimum is 300: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for VRRP. • When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. Save the configuration and reload the system for the delay timers to take effect. Related Command vrrp delay minimum - sets the delay time for VRRP initialization after a line card reboot. vrrp-group Assign a VRRP ID to an interface. You can configure up to 255 VRRP groups per interface. C9000 Series Syntax Parameters vrrp-group vrrp-id vrrp-id Enter a number as the group ID. The range is from 1 to 255. Defaults Not configured. Command Modes INTERFACE 2088 Virtual Router Redundancy Protocol (VRRP)