Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 369

To enable OSPFv2 routing, follow these steps. Step Command Syntax 1 ip address ip-address mask If using a loopback interface, refer to Loopback Interfaces on page 230. 2 no shutdown Command Mode CONFIG-INTERFACE CONFIG-INTERFACE Usage Assign an IP address to an interface. Format: A.B.C.D/M Enable the interface. To enable the OSPF process, return to CONFIGURATION mode. The OSPF process ID is the identifying number assigned to the OSPF process and the Router ID is the IP address associated with the OSPF process. Command Syntax router ospf process-id Command Mode CONFIGURATION Usage Enable the OSPFv2 process globally. Range: 1-65535 If you try to enter an OSPF process ID, or if you try to enable more OSPF processes than available Layer 3 interfaces, prior to assigning an IP address to an interface and setting the no shutdown command, you will see the following message. Message 3 FTOS(conf)#router ospf 1 % Error: No router ID available. In CONFIGURATION ROUTER OSPF mode, assign the router ID. The router ID is not required to be the router's IP address. Dell Force10 recommends using the IP address as the router ID for easier management and troubleshooting. Command Syntax router-id ip address Command Mode Usage CONFIG-ROUTER-OSPF-id Assign the Router ID for the OSPFv2 process. IP Address: A.B.C.D To disable OSPF, use the no router ospf process-id command in CONFIGURATION mode. To reset the OSPFv2 process, use the clear ip ospf process-id command in EXEC Privilege mode. To view the current OSPFv2 status, use the show ip ospf process-id command in EXEC mode (Figure 18-8). Open Shortest Path First (OSPFv2) | 367