Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Configuration Guide for E-Series TeraS - Page 1144

www.dell.com | support.dell.com Sample Configurations VRRP for IPv4 Configuration The configuration in Figure 58-21 shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your own IP addresses, interfaces, names, etc. Figure 58-21 shows the VRRP topology created with the CLI configuration in Figure 58-22. Figure 58-21. VRRP for IPv4 Topology State Master: R2 interface has the higher VRRP group priority (200) Virtual MAC is automatically assigned and is the same on both Routers R2#show vrrp GigabitEthernet 2/31, VRID: 99, Net: 10.1.1.1 State: Master, Priority: 200, Master: 10.1.1.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 661, Gratuitous ARP sent: 1 Virtual MAC address: 00:00:5e:00:01:63 Virtual IP address: 10.1.1.3 Authentication: (none) R2# State Backup: R3 interface has the lower VRRP group priority (100) R3#show vrrp GigabitEthernet 3/21, VRID: 99, Net: 10.1.1.2 State: Backup, Priority: 100, Master: 10.1.1.1 Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 331, Bad pkts rcvd: 0, Adv sent: 0, Gratuitous ARP sent: 0 Virtual MAC address: 00:00:5e:00:01:63 Virtual IP address: 10.1.1.3 Authentication: (none) R3# 10.1.1.1 GigE 2/31 10.1.1.2 GigE 3/21 R2 VRID 99 10.1.1.3 R3 Internet 1144 | Virtual Router Redundancy Protocol (VRRP)