Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Configuration Guide for E-Series TeraS - Page 359

Table 16-1. Pre-defined Policy Test Lists Condition Conditions Tested Hardware Hardware Status SFM status transition from active to another state RPM status transition from active to another state Line Card transition from active to another state Port-pipe error or transition to down PEM transition from up to another state AC PSU transition from up to other state Fan Tray down or individual fan down Environmental status Overtemp for each item listed in show environment Over/under-voltage for each item listed in show environment Software SWP Timeout, IPC Timeout, IRC timeout, CPU > 85%, Memory usage > 85% To add a pre-defined list of conditions to your policy test list: Task Command Add a pre-defined list of conditions to default-test [exception | hardware | your policy test list. software] Command Mode CALLHOME TESTLIST Table 16-2 shows the test conditions that are available to add to a custom policy test list. See the Dell Force10 MIB for further description of the given Object Identifiers (OID). You may only specify one test condition within a policy. Table 16-2. Custom Policy Test Conditions Condition Keyword Description OID CPU Usage cpu-1-min cpu-5-min Interface Rate/ interface-bit-rate Throttles interface-rate interface-throttles Interface Errors interface-crc CPU utilization in percentage for the chRpmCpuUtil1Min last 1 minute. CPU utilization in percentage for the chRpmCpuUtil5Min last 5 minutes. Interface bandwidth in bits/second. Interface bandwidth in packets/ second. The total number of valid ingress frames with a length or type field value equal to 0x8808 (Control Frame). f10IfInThrottles f10IfOutThrottles Frames received with a length f10IfInCRC between 64 and 1518 octets, inclusive, that had an incorrect CRC. Force10 Service Agent | 359