Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Configuration Guide for E-Series TeraS - Page 469

Command Syntax ip domain-lookup ip name-server ipv4-address [ipv4-address2 ... ipv4-address6] ipv6 name-server ipv6-address [ipv6-address2 ... ipv6-address6] Command Mode CONFIGURATION CONFIGURATION Purpose Enable dynamic resolution of host names. Specify up to 6 IPv4 or IPv6 name servers. The order you entered the servers determines the order of their use. You may have IPv4 and IPv6 name servers configured at the same time. To view current bindings, use the show hosts command. Figure 21-5. show hosts Command Example FTOS>show host Default domain is force10networks.com Name/address lookup uses domain service Name servers are not set Host Flags TTL -------- ----- ---- ks (perm, OK) - patch1 (perm, OK) - tomm-3 (perm, OK) - gxr (perm, OK) - f00-3 (perm, OK) - FTOS> Type ---- IP IP IP IP IP Address ------2.2.2.2 192.68.69.2 192.68.99.2 192.71.18.2 192.71.23.1 To view the current configuration, use the show running-config resolve command. Specify local system domain and a list of domains If you enter a partial domain, FTOS can search different domains to finish or fully qualify that partial domain. A fully qualified domain name (FQDN) is any name that is terminated with a period/dot. FTOS searches the host table first to resolve the partial domain. The host table contains both statically configured and dynamically learnt host and IP addresses. If FTOS cannot resolve the domain, it tries the domain name assigned to the local system. If that does not resolve the partial domain, FTOS searches the list of domains configured To configure a domain name, use the following command in the CONFIGURATION mode: Command Syntax ip domain-name name Command Mode CONFIGURATION Purpose Configure one domain name for the E-Series To configure a list of domain names, use the following command in the CONFIGURATION mode: IPv4 Addressing | 469