Dell Inspiron Mini 9 910 Inspiron Mini 9 Service Manual - Page 2

Back to Contents Page Module Cover Dell™ Inspiron™ 910 Service Manual Removing the Module Cover Replacing the Module Cover CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: Before performing this procedure, turn off the computer, disconnect the AC adapter from the electrical outlet and the computer, disconnect the modem from the wall connector and the computer, and remove any other external cables from the computer. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer). Removing the Module Cover 1. Follow the instructions in Before You Begin. 2. Remove the two screws on the module cover. 3. Lift the cover off the computer at an angle as shown in the figure. 1 module cover 3 screw (2) 2 module cover tab (3) Replacing the Module Cover 1. Align the tabs on the module cover to the bottom of the computer and gently replace the module cover. 2. Replace and tighten the two screws on the module cover. 3. Slide the battery into the battery bay, until it clicks into place. 4. Slide the battery-lock latch to the lock position. Back to Contents Page