Dell Latitude D620 ATG Service Manual - Page 32

Disconnect the touch-pad cable connector from the system board.

Get Dell Latitude D620 ATG PDF manuals and user guides View all Dell Latitude D620 ATG manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

11. Remove the seven M2.5 x 8-mm screws from the bottom of the computer. NOTICE: Carefully separate the palm rest from the base to avoid damage to the palm rest. 12. Turn the computer top-side up and remove the palm rest. a. Starting at the back center of the palm rest, use your fingers to separate the palm rest from the base by lifting the inside edge of the palm rest. b. After the back of the palm rest is unsnapped, push the palm rest slightly forward to unhook the remainder of the palm rest from the front of the base. 13. Disconnect the touch-pad cable connector from the system board. 1 touch pad connector NOTICE: When reinstalling the palm rest, ensure that you reconnect the touch pad cable connector to the system board before replacing the palm rest screws. Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
11.
Remove the seven M2.5 x 8-mm screws from the bottom of the computer.
12.
Turn the computer top-side up and remove the palm rest.
a.
Starting at the back center of the palm rest, use your fingers to separate the palm rest from the base by lifting the inside edge of the palm rest.
b.
After the back of the palm rest is unsnapped, push the palm rest slightly forward to unhook the remainder of the palm rest from the front of the
base.
13.
Disconnect the touch-pad cable connector from the system board.
Back to Contents Page
NOTICE:
Carefully separate the palm rest from the base to avoid damage to the palm rest.
1
touch pad connector
NOTICE:
When reinstalling the palm rest, ensure that you reconnect the touch pad cable connector to the system board before replacing the palm rest
screws.