Dell Latitude E6400 ATG Service Manual - Page 46
Removing the Fan, Replacing the Fan
View all Dell Latitude E6400 ATG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Back to Contents Page Fan Dell™ Latitude™ E6400 and E6400 ATG and Mobile Workstation Precision™ M2400 Service Manual Removing the Fan Replacing the Fan Removing the Fan CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. 1. Follow the instructions in Before Working on Your Computer. 2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly). 3. Remove the two M2.5 x 5-mm screws that secure the fan to the processor heatsink assembly. 4. Disconnect the fan cable from the system board. 5. Lift the fan up at a 45-degree angle, and pull it away from the flap on the processor heatsink assembly to remove it. 1 fan 2 M2.5 x 5-mm screws (2) 3 fan cable Replacing the Fan CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. 1. Lift the flap on the heatsink assembly and insert the fan at an angle. 2. Align the screws holes in the fan with the screw holes in the processor heatsink assembly. 3. Replace the two M2.5 x 5-mm screws to secure the fan to the processor heatsink assembly. 4. Connect the fan cable to the system board. 5. Replace the bottom of the base assembly (see Removing the Bottom of the Base Assembly). 6. Follow the procedures in After Working on Your Computer.