Dell OptiPlex 5080 Small Form Factor Service Manual - Page 42
Installing the system board
View all Dell OptiPlex 5080 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Steps 1. Remove the screw (6-32) that secures the I/O panel. 2. Lift the I/O panel away from the system board. 3. Disconnect the intrusion switch cable. 4. Disconnect the system board power supply cables. 5. Disconnect the power button switch cable. 6. Disconnect the system fan cable. 7. Disconnect the processor power supply cable. 8. Disconnect the SATA cables. 9. Disconnect the SATA power cable. 10. Disconnect the internal speaker cable. 11. Remove the four Screws (6-32) and the single standoff screw (M2X4). 12. Lift and slide the system board out. Installing the system board Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the system board and provides a visual representation of the installation procedure. 42 Field service information