Dell OptiPlex 5080 Small Form Factor Service Manual - Page 49

Diagnostic error messages

Get Dell OptiPlex 5080 Small Form Factor PDF manuals and user guides View all Dell OptiPlex 5080 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

Table 7. Diagnostic LED behavior (continued) Blinking pattern Amber White 3 7 4 2 Problem description Suggested resolution ● If problem persists, replace the system board. Intel ME (Management Engine) Error ● Timeout waiting on ME to reply to HECI message ● If problem persists, replace the system board. CPU Power Cable Connection Issue Diagnostic error messages Table 8. Diagnostic error messages Error messages AUXILIARY DEVICE FAILURE BAD COMMAND OR FILE NAME CACHE DISABLED DUE TO FAILURE CD DRIVE CONTROLLER FAILURE DATA ERROR DECREASING AVAILABLE MEMORY DISK C: FAILED INITIALIZATION DRIVE NOT READY ERROR READING PCMCIA CARD EXTENDED MEMORY SIZE HAS CHANGED THE FILE BEING COPIED IS TOO LARGE FOR THE DESTINATION DRIVE A FILENAME CANNOT CONTAIN ANY OF THE FOLLOWING CHARACTERS GATE A20 FAILURE GENERAL FAILURE Description The touchpad or external mouse may be faulty. For an external mouse, check the cable connection. Enable the Pointing Device option in the System Setup program. Ensure that you have spelled the command correctly, put spaces in the proper place, and used the correct path name. The primary cache internal to the microprocessor has failed. Contact Dell The optical drive does not respond to commands from the computer. The hard drive cannot read the data. One or more memory modules may be faulty or improperly seated. Reinstall the memory modules or, if necessary, replace them. The hard drive failed initialization. Run the hard drive tests in Dell Diagnostics. The operation requires a hard drive in the bay before it can continue. Install a hard drive in the hard drive bay. The computer cannot identify the ExpressCard. Reinsert the card or try another card. The amount of memory recorded in non-volatile memory (NVRAM) does not match the memory module installed in the computer. Restart the computer. If the error appears again, Contact Dell The file that you are trying to copy is too large to fit on the disk, or the disk is full. Try copying the file to a different disk or use a larger capacity disk. Do not use these characters in filenames. A memory module may be loose. Reinstall the memory module or, if necessary, replace it. The operating system is unable to carry out the command. The message is usually followed by specific information. Troubleshooting 49

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
Table 7. Diagnostic LED behavior (continued)
Blinking pattern
Problem description
Suggested resolution
Amber
White
●
If problem persists,
replace the system board.
3
7
Intel ME (Management
Engine) Error
●
Timeout waiting on ME to
reply to HECI message
●
If problem persists,
replace the system board.
4
2
CPU Power Cable Connection
Issue
Diagnostic error messages
Table 8. Diagnostic error messages
Error messages
Description
AUXILIARY DEVICE FAILURE
The touchpad or external mouse may be faulty. For an
external mouse, check the cable connection. Enable the
Pointing Device
option in the System Setup program.
BAD COMMAND OR FILE NAME
Ensure that you have spelled the command correctly, put
spaces in the proper place, and used the correct path name.
CACHE DISABLED DUE TO FAILURE
The primary cache internal to the microprocessor has failed.
Contact Dell
CD DRIVE CONTROLLER FAILURE
The optical drive does not respond to commands from the
computer.
DATA ERROR
The hard drive cannot read the data.
DECREASING AVAILABLE MEMORY
One or more memory modules may be faulty or improperly
seated. Reinstall the memory modules or, if necessary, replace
them.
DISK C: FAILED INITIALIZATION
The hard drive failed initialization. Run the hard drive tests in
Dell Diagnostics
.
DRIVE NOT READY
The operation requires a hard drive in the bay before it can
continue. Install a hard drive in the hard drive bay.
ERROR READING PCMCIA CARD
The computer cannot identify the ExpressCard. Reinsert the
card or try another card.
EXTENDED MEMORY SIZE HAS CHANGED
The amount of memory recorded in non-volatile memory
(NVRAM) does not match the memory module installed in the
computer. Restart the computer. If the error appears again,
Contact Dell
THE FILE BEING COPIED IS TOO LARGE FOR THE
DESTINATION DRIVE
The file that you are trying to copy is too large to fit on the
disk, or the disk is full. Try copying the file to a different disk
or use a larger capacity disk.
A FILENAME CANNOT CONTAIN ANY OF THE
FOLLOWING CHARACTERS: \ / : * ? " < > | -
Do not use these characters in filenames.
GATE A20 FAILURE
A memory module may be loose. Reinstall the memory module
or, if necessary, replace it.
GENERAL FAILURE
The operating system is unable to carry out the command.
The message is usually followed by specific information.
Troubleshooting
49