Dell OptiPlex GX100 User Guide - Page 73
Troubleshooting Drives, Diagnostics, Troubleshooting System Memory, System Setup, Troubleshooting
View all Dell OptiPlex GX100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Diskette drive 1 seek failure Diskette read failure Diskette subsystem reset failed Drive not ready Diskette write protected Gate A20 failure General failure Hard disk configuration error Hard disk controller failure Hard disk failure may not match the hardware configuration. A cable may be loose, or the diskette may be faulty. See "Troubleshooting Drives." The diskette drive controller may be Run the Diskette tests in the Dell faulty. Diagnostics. No diskette is in the drive. The Put a diskette in the drive or close the operation requires a diskette in the drive latch. drive before it can continue. The diskette write-protect feature is Remove the diskette from drive A and activated. move the write-protect tab to the unlocked position. One or more DIMMs may be loose. See "Troubleshooting System Memory." The operating system is unable to carry out the command. This message is usually followed by specific information-for example, PRINTER OUT OF PAPER. Respond by taking the appropriate action. The hard-disk drive failed initialization. See "Troubleshooting Drives." The hard-disk drive failed initialization. See "Troubleshooting Drives." Hard-disk drive read failure Invalid configuration information - please run SETUP program Keyboard clock line failure Keyboard controller failure The system configuration information does not match the hardware configuration. Enter System Setup and correct the system configuration information. A cable or connector may be loose, See "Troubleshooting the Keyboard." or the keyboard or keyboard/mouse controller may be faulty. Keyboard data line failure Keyboard failure Keyboard stuck key failure Memory address line failure at address, read value expecting value Memory allocation error Memory data line failure at address, read value expecting value One or more DIMMs may be faulty or improperly seated. The software you are attempting to run is conflicting with the operating system or another application program or utility. One or more DIMMs may be faulty or improperly seated. See "Troubleshooting System Memory." Turn off the computer, wait 30 seconds, and then turn it on. Try to run the program again. If the problem persists, contact the software company. See "Troubleshooting System Memory." Memory double word logic failure at address, read value expecting value Memory odd/even logic failure at address, read value expecting value Memory write/read failure at address, read value expecting value Memory size in CMOS invalid Memory tests terminated by keystroke No boot device available No boot sector on hard-disk drive The amount of memory recorded in Reboot the computer. If the error appears the system configuration information again, see "Getting Help" for instructions does not match the memory on obtaining technical assistance. installed in the computer. The memory test did not complete. Rerun the memory test. The computer cannot find the diskette or hard-disk drive. Enter System Setup, check the system configuration information for the diskette and hard-disk drive, and if necessary, correct the information. The system configuration Enter System Setup, check the system information in System Setup may be configuration information for the hard-disk incorrect, or the operating system drive, and if necessary, correct the may be corrupted. information.