Dell OptiPlex GX260N Service Manual - Page 32

Serial Port Adapters, Installing a Serial Port Adapter

Get Dell OptiPlex GX260N PDF manuals and user guides View all Dell OptiPlex GX260N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Serial Port Adapters Installing a Serial Port Adapter CAUTION: Before you perform this procedure, see "Precautionary Measures." 1. Lift the tab on the card retention arm and raise the retention arm (see "Raising the Retention Arm"). 2. Remove the filler bracket. 3. Slide the card bracket down over the card-slot opening, and ensure that the top of the card bracket is flush with the alignment bar and the notch in the top of the card bracket fits around the alignment guide (see "Closing the Retention Arm"). 4. Attach the serial card cable to the connector on the system board (labeled SER2). Installing a Serial Port Adapter 1 SER2 system board connector 2 card bracket 3 serial card cable 4 card-slot opening

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
Serial Port Adapters
Installing a Serial Port Adapter
CAUTION:
Before you perform this procedure, see "
Precautionary Measures
."
1. Lift the tab on the card retention arm and raise the retention arm (see "
Raising the Retention Arm
").
2. Remove the filler bracket.
3. Slide the card bracket down over the card-slot opening, and ensure that the top of the card bracket is flush with the
alignment bar and the notch in the top of the card bracket fits around the alignment guide (see "
Closing the Retention
Arm
").
4. Attach the serial card cable to the connector on the system board (labeled SER2).
Installing a Serial Port Adapter
1
SER2 system board
connector
2
card bracket
3
serial card cable
4
card-slot opening