Dell PowerConnect 6224P User's Guide - Page 615
Table 10-2., IPv6 Interface Routing Commands, CLI Command, Description
View all Dell PowerConnect 6224P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 615 highlights
Table 10-2. IPv6 Interface Routing Commands CLI Command ipv6 address ipv6 enable ipv6 host ipv6 mtu ipv6 nd dad attempts ipv6 nt managed-config-flag ipv6 nd ns-interval ipv6 nd other-config-flag ipv6 nd prefix ipv6 nd ra-interval ipv6 nd ra-lifetime ipv6 nd reachable-time ipv6 nd suppress-ra show ipv6 traffic show ipv6 vlan Description Configures an IPv6 address on an interface (including tunnel and loopback interfaces). Enables IPv6 routing on an interface (including tunnel and loopback interfaces) that has not been configured with an explicit IPv6 address. Defines static host name-to- ipv6 address mapping in the host cache. Sets the maximum transmission unit (MTU) size, in bytes, of IPv6 packets on an interface. Sets the number of duplicate address detection probes transmitted while doing neighbor discovery. Sets the "managed address configuration" flag in router advertisements. Sets the interval between router advertisements for advertised neighbor solicitations. Sets the "other stateful configuration" flag in router advertisements sent from the interface. Sets the IPv6 prefixes to include in the router advertisement. Sets the transmission interval between router advertisements. Sets the value that is placed in the Router Lifetime field of the router advertisements sent from the interface. Sets the router advertisement time to consider a neighbor reachable after neighbor discovery confirmation. Suppresses router advertisement transmission on an interface. Shows traffic and statistics for IPv6 and ICMPv6. Displays IPv6 VLAN routing interface addresses. Configuring IPv6 615