Dell PowerEdge 2650 Rack Installation Guide - Page 16
Installing the VersaRails Slide Assemblies
View all Dell PowerEdge 2650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
www.dell.com | support.dell.com Installing the VersaRails Slide Assemblies 1 At the front of the rack cabinet, position one of the VersaRails slide assemblies so that its mounting-bracket flange fits between the marks or tape (or numbered location) on the rack (see Figure 1-6). The four holes on the front of the mounting bracket should align with four of the holes between the marks you made on the front vertical rail. 2 Install two 10-32 x 0.5-inch flange-head Phillips screws in the mounting flange's top hole and the third-from-top hole to secure the slide assembly to the front vertical rail (see Figure 1-6). 3 At the back of the cabinet, pull back on the mounting-bracket flange until the mounting holes align with their respective holes on the back vertical rail. 4 Install two 10-32 x 0.5-inch flange-head Phillips screws in the back mounting flange's top and third-from-top holes to secure the slide assembly to the back vertical rail. 5 Repeat steps 1 through 4 for the slide assembly on the other side of the rack. 6 Ensure that the slide assemblies are mounted at the same position on the vertical rails on each side of the rack. 1-10 Rack Installation Guide