Dell PowerEdge T710 Tower-to-Rack Conversion Guide - Page 6
Rotating the LCD Display Module, Installing the Rack Ears, Installing the Bezel
View all Dell PowerEdge T710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Rotating the LCD Display Module 1 Remove the optical drive from the top (or left) drive bay of the system. a Disconnect the power and data cables from the back of the optical drive. See Figure 1-1. b Slide the drive release latch in the direction of the arrow to release the drive. c Slide the drive out to remove it from the drive bay. 2 Rotate the LCD display module 90 degrees clockwise to the horizontal rack orientation. 3 Reinstall the optical drive in the system. a Align the shoulder screws on the optical drive with the drive bay screw slots. b Insert the optical drive into the drive bay until the release latch locks into place. c Reconnect the power and data cables to the back of the optical drive. 4 Close the top chassis panel. 5 Close the system cover. Installing the Rack Ears 1 Align the rack ear screw holes with the screw holes on the right side of the system chassis. See Figure 1-2. 2 Install the three screws using a #2 Phillips screwdriver. 3 Repeat for the left rack ear piece. Installing the Bezel 1 Insert the tabs at the bottom of the bezel into the tab slots at the bottom of the chassis. 2 Firmly press the top of the bezel into the chassis until the lever locks into place. 3 Using the system key, lock the bezel. 6 Tower-to-Rack Conversion Guide